what is the difference between id fans and fd
fans
- 12 Answers
- 153292 Views
- Perkins Thermal Systems, I also Faced
- E-Mail Answers
Answer Posted / mitesh
id fan maens induce draet ean & fd ean is froce draft
fan.both are use in thermal power plant.id fan so connected
the airpreheater.fd fan is so connect the eletropre-preted.
| Is This Answer Correct ? | 61 Yes | 193 No |
Post New Answer View All Answers
Can anybody post questions asked in Engineers India Limited Interview? Thanks in advance.
im working in one private compeny in gujarat. i was complet diploma electric in 2010 from gujarat technical board. now i want electric supervisor licence in gujarat but i dont't know when i apply? plz give me address of the licence dippartment office in gujarat. gandhinagar
what is sevice settings for mccb?How can be it setted?
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
we use capister for power factor. when we use capaciter in dg circuit than defect dg. can we use capaciter bank for dg circuit
What will be the current drawn by HT motor, if low voltage is applied.. any formula to calculate the LT amps of HT motor.?
What happens if the Capacitive Voltage Transformer Primary neutral is not earthed. There is a CVT between Transformer and source, and the CVT neutral of the transformer is not earthed, does it effect the transformer while charging or does it effect the transformer charging process.
What is the tube exial fan?
i have gear oil pump with single phase motor.some time its motor starts running in reverse direction rather than forward direction...whats the reason behind this issue. 1- either capacitor is week? 2- or winding is week?
What is Tachometer used to measure?
i need to give section engineer (electrical engineer) for RRB. Please suggest some book
difference between servo motor and synchronous motor
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
is that a problem if i connect a single phase load to a secondry delta connected transformer but i get a neutral from other transformer i the system?
Define relative stability.
