Interested to Buy Any Domain ? << Click Here >> for more details...
1.How a chlorine leak is detected?
2.What would happen if excess chlorine is added to water in
cooling tower?
- 3 Answers
- 8362 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajan
For chlorine leak, above answer is correct. And if excess
chlorine is added in water normally it leads to corrosion
in pipeline & chlorine level will reduce when it spray in
cooling tower by contact with atmospher air.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Explain how do you design a vapor-liquid separator or a flash drum?
MY generator water cooler inlet line height - 11 mtr inlet water line height - 7 mtr water come into the line from overhead tank, O/H tank height - 20 mtr the first tapping in the inlet line is 2" line which down to 4 mtr level plateform., second tapping in inlet water line goes to a pump 6" line installed at 4 mtr level plateform, pump capacity 200m3/hr, head- 30 mtr, hp-40. the outlet of pump of 6" water line connected to a header of 6 mtr long of 6" line, on this header the six tapping are connected, 4 nos. 3" line goes to 11 mtr height water cooler the pressure of the line is 0.15 to 0.25 kg/cm2, 2" and 4" pipe line connected to a cooler at 4 mtrlevel plateform. my question is, at 11 mtr height level the quantity of water and flow is not sufficient for my cooler, the temp. of cooler is rises much more. you are requested to suggest the modification of pipe line/ pump for take more water flow and pressure (desired pressure is 1 kg/cm2)
can anyone send me the written test paper of Indian oil corporation ltd. My email id is pratuljakhmola@yahoo.com
Hi.. Me going to tke test for management trainee(technical) Post I am an chemical engineering student . Can u guide how to prepare for this test.Can u send me test paper pattern..?
What type of heat exchangers are most commonly used for a large-scale plant-cooling loop using seawater as the utility?
Define a solvent?
What type of pump may be appropriate for a liquid near saturation, a low flow rate, and very limited npsha?
What are the strategies acquired to cure tube vibration and exchangers in a shell?
How can you separate hydrogen peroxide into hydrogen and oxygen?
hi can anyone tell me some technical questions asked in iocl
When an expansion is joint needed on the shell side of a shell and tube heat exchanger?
Is four stage graphite steam jet ejector is possible. Any body can provide its design
if i added hypo before DM plant so i will affect my resins of anion or cation. if affect it so do prevent what kind of step should be taken to remove hypo before DM inlet?
What is screen analysis and what are its applications in the chemical industry?
What is the maximum recommended velocity for steam in a plant pipe network?
