The power required for size reduction in crushing is???
- 5 Answers
- 8034 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajesh
power required for crushing the material mainly depends on
the product size it means surface energy of the material. so
if the product size is very fine then the power
requirement is more.
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
Mention some of the specialized grinding methods?
What are pcbs?
We have some pieces of metals that have been 'powder coated', how does that work?
Is there a handy way to determine if a horizontal pipe is running full if the flow rate is known?
What are some good estimates for heat transfer coefficients for coils in tanks?
What is the basic difference between dispersion & distribution in any polymer blend or alloy??
Explain what are some good uses of low-grade steam at 12 atm and 1920c?
white rust formation over zinc plated and yellow passivated fasteners during CED painting. WHY?
any meter avilable for measureing the Transformer Losses. ( like Voltmeter for voltage & ammiter for currenr )if yes plz give the make & supplier address, Email, Phone number.
what is the difference between car seal close/open valves and lock close/open valves?
why 14.7 pound/inch2 is used in idustries as unit of pressure bcz here not sea level and not a temperature is 0C (zero degree celcius)?????????
What type of pump may be appropriate for a liquid near saturation, a low flow rate, and very limited npsha (net positive suction head available)?
What are some factors to consider when trying choosing between a dry screw compressor and an oil-flooded screw compressor?
Explain the use of gear pumps in motor?
Explain what type of flow measurement devices is best for slurries?
