how to identify the direction flow of electrons in a
conductor?
if i want to check the sequence in kv lines, is any device
is available?
- 3 Answers
- 4761 Views
- I also Faced
- E-Mail Answers
Answer Posted / ankush miglani 09718151073
yes u can easily check it throug the ammeter or thru
galvanometer
the flow of electrons is always oppotite to that of the
flow of current
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is Instantaneous Earth fault relay,how will work
what is the series parallel connection of capacitors? and how can we use these application in three phase motors for controlling torque?
What is the formula to find out two phase active & reactive power
Is better to supply the voltage for static exciter from the auxiliary power source or from the SG terminals? And why?
L.A. (Lightening Arrester) is located at a place from where transmission line enters the transmitting substation. So L.A. (Lightening Arrester) is the first equipments which has to encounter with lightening, high voltage surges and switching surges. It has to absorb energy of lightening, high voltage surges, and switching surges. L.A. (Lightening Arrester) is made up of layers of semiconductors. If these layers can not tolerate energy released by lightening, high voltage surges, and switching surges the L.A. (Lightening Arrester) blasts.
how we will deside the high voltage value
What is depreciation factor?
WHY NUTRAL GROUND SYSTEM USED IN 33KV SYSTEM
What is current & voltage ? Voltage perform at any load without current or not?
How is the gain affected by the introduction of feedback in a control system.
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
How to select the proper VSD to operate high inertial load
How to calculate the Efficiency of Chiller
Which device is used for the source of emission of electrons in a crt?
What is inrush current? how can calculateit? what is the affect of it?
