In footing (mat) if two different dia of rods are to be used
which rod should be placed at top and bottom ( eg. 10mm &
16mm dia rods)
Answer Posted / ramesh k
Always bigger dia should be laid at bottom and it should be
provided on shorter directions.but for cantilever beams and
sunshade bigger dia should be laid at top,the reason is the
mat shold be laid at top.
Is This Answer Correct ? | 11 Yes | 1 No |
Post New Answer View All Answers
how to estimate material requirement for an area of house in square feet?
I just got a first job in Maharashtra and m a fresher. My task is estimate the cost of excavation of earth with J.C.B. can anyone tell me how to do this??
01. a. Diagram of a slump cone…………… 1 b. Size of Slump Cone…………… 1 c. Volume of a slump cone by av. Dia method…………… 1 d. Volume of a slump cone by av. area method…………… 1 e. Volume of a slump cone by frustrum method …………… 1 f. Angles of slump cone …………… 1 g. Slump measured by slump cone due to…………… 1 h. Slump does not measured by cylinder / cube due to …………… 1 i) ii) i. Slump cone is to be filled in……………………..Layers.
What is the force exerted by the tacoma narrows bridge?
How to improve the strength of fly ash bricks to avoid corner damge? How to get the color lighter similar to normal concrete blocks/
foundation details for 25 ton weight Furnace on 2 supports and 2 tilters
how to find quantity of concrete in PCC M15
1. HOW MUCH CEMENT AND SAND REQUIRED TO PLASTER 100 SQM WALL. 2. HOW MUCH CEMENT AND SAND REQUIRED FOR SCREED WORK OF AREA 30 SQM
(Project Management Topic) What are the important criteria in the successful realization of the project?
One plate (women civil worker lifting Plate - Satti) sand measures how many cubic feet?
Floor tile measurement? Wall to wall or skirting to skirting
what is the water-cement ratio of mix design while 30mpa in 7 days?
in one SQM plaster how much Cement and sand consumed in ratio 1:4
How many hours should traffic be not allowed after completing wbm road or bst.and min how many hours should road rollers be used.
Why should you show Client/Engineer activities clearly on the project plan?