how the lap length is calculated in reinforcement of 110mm
dia steel of Length 15.00 mtrs. & grade of concrete is M20
Answer Posted / rammy
Lap Length is equal to
50D for Tension zone : 50*10 =500 mm
45D for compression zone : 45*10 =450 mm
Is This Answer Correct ? | 84 Yes | 23 No |
Post New Answer View All Answers
what is tension column?
What is c.g.i sheet which used for roof??
What is capicity of cap lock scffolding stander(vertical member) and ledger of different size?
How to make tiles floor step by step procedure?
What is the release of lien?
Explain what are the problems one might face while having a Cantilever balcony?
If we have the center line of the Finnish road level and we want to know what level of pay would have offset the Lhs and Rhus RHS 1,2.5,5 1,2.5,5 m.
if i used salt as a add mixture in concrete, then what will happen and what are the naturally available add mixtures.
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
B.M DIAGRAMS & S.F DIAGRAMS OF CONTINOUS BEAMS
What distance in meters on the ground is the equivalent of one second of arc in longitude or latitude?
please send me bhel questions on rupesh.017@rediffmail.com
What are advancements in civil engineering?
Sir, Iam Applied in rrb for the posts of Junior Engineer.I want to know about the or question previews to study well.Pl send it to shukla_varun1985@yahoo.com.
In few lines, please be elaborative on extras and talents that make you a potential candidate for the post: