Answer Posted / shahzad
square root extractor is using for flow measurement
Is This Answer Correct ? | 98 Yes | 11 No |
Post New Answer View All Answers
how works encoder in plc
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
what are the different types of Protocols? & their applications.
What is cut off relay? And why use in PLC and DCS?
i have steam drum height 1000mm. and i want to placed the transmitter below the tap.how i calculate.
principle of dead weight tester ?
Why MUX JB's are using only Temperature Element in Fundation field bus?
what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail
you are on site,the plant trips,you are approached by operations,what do you do?
What is the use of temperature compensation?
Which are all the commonly used Bordon tubes in the pressure gauges. Do any one use ASTM A 312 tubes for this purpose?
what is the different between deflection type measurement and null type measurement in RTD?
sir, give me placement papers and interview quistion of birla group company of copper.
Explain about safety integrated level protection? . How it was differ from other protections ?
Explain the use of hair spring in the pressure gauge.