Interested to Buy Any Domain ? << Click Here >> for more details...
an electric bulb is connected on a holder. one end of the wire
is connected to the phase and the remaining one connected to
earth instead of neutral. the bulb will glow or not? if yes
then what is the need of neutral?
- 7 Answers
- 14066 Views
- I also Faced
- E-Mail Answers
Answer Posted / deepak
The need of Neutral: It gives assurance of reliable
centralised earthing as your home may or may not have
reliable earthing.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Can the output voltage of a rectifier be greater than the input AC voltage without the use of any voltage multiplier in the circuit??please provide the explanation too..
How many kw will suply from one db
i have applied for junior engineer 2 c&w for Guwahati RRB please send me last five year question paper
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
what heppend if we are connected u1-v1-w1 as a star point in the place of u2-v2-w2 in power genration
please give me all the Alarm .Trip ,Safety Relays & Conditions of Chiller mail me on ashokbabunhce@gmail.com
1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?
What is the restart inhabit setting in ABB spam150c relay (Motor protection relay)
what are the advantages disadvantages of connecting high voltage block( 1:1 transformers) transformers between the turbo generators and busbars.
plz send me the placement interview question and answers of whizchip(technical and apttitude)..i have an interview in next.
What is dc current source? Differentiate between ideal and non ideal current sources?
As an electrical engineer what are the responsibilities which i can hold in TCS?
where solid grounding and where grounding through ngr done and why?
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
