can we check the resistance of earthing electrode while it
is connected with the neutral of UPS system
Answer Posted / zan
It should be checked accordingly the resistance used for
the solid system earthing.
In low voltage system erathing, the secondry winding of
distribution transformer, low voltage generator or UPS
system are normally solidly earthed. Solidly earthing of
the system means that the system voltage will never exceed
the phase voltage.
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what is the use of permanent magnet generator in exciter
WHAT ARE THE CHARACTERISTICS OF AN VOLTAG AMPLIFIER
what are the range of memory address in plc for L&T lx7 4A
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
TCS IS IT COMPANY THEN WHY DO THEY NEED ELECTRICAL &ELECTRONICS ENGINEERS?
We have 5 Distribution sections with variable loads&We have 3 Gensets(500kva,380kva&250kva) our total load is between 400kva to 600kva. so how could we connect 3gensets.
2. Modify your design in question 1.a so that the circuit works according to the following function table X Y F 0 0 Clear 0 1 No Change 1 0 Parallel Loading 1 1 Count 3. Design a circuit that detects the pattern 010 in a serial input X considering: 3.a Overlapping 3.b No overlapping
In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?
why current flow to the opposite direction of flow of electrons???????????
Dear Brother can u tell the proper size selection of cable & the fault level calculation of braker, busbar etc. pls mail me at azeemk30@gmail.com
Hello seniors m an engineering student in 3rd yr..i want to know what are the software course in electrical field?i wanted to do certification course but i dont know much about the course?..Regards
Why does an induction generator is preffered as compared to synchronous generator in especially a wind energy power production project?
What is electrical cable termination
how we can come to know that motor winding resistance which showing by DMM is right or wrong???is there any chart or something that we will compare & check???
Why the output of OP-AMP is always less than Vcc?