why in three phase 440 circuit in all phase current is
almost equal L1-35 A,L2-34 A ,L3-31 A but in nutral when i
check with clamp meter it shows 25 A?
- 4 Answers
- 11743 Views
- OPS, I also Faced
- E-Mail Answers
Answer Posted / anil
1)your point of measuring to conder again
2)check whether nutral joint is given to another load which
you not considering for this load
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is ideal IR values for ground and neutral.
gas turbine genrator reactances
WHAT IS ELECTRICAL MAINTAINTENCE ?
what is the principle of operation of tungstun bulb ??
Why Water motor is not taking a load or pressure while everything is correct. (Note: Motor running properly)
STATE USE OF ARC RUNNERS & SPLITTERS ?
Where is servomechanism used?
Scott connection is used for A 3-phase to 2-phase conversion B to achieve higher effciency C to save copper D to reduce harmonics
detailed procedure how we calculate cost for pcc m10 and rcc m20 including centering and labour excluding steel/ iron
What it the purpose of parallel phasing transfomers??
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
what are the basic insulation levels & what its Unit
why we setting 95 deg and 105 deg in wti and oti of distibution transformer ? give the reson for that ?
What are the two segments of nyquist contour.
how load of a turbo generator can be increased
