in pressure gauge inside why we are using the glasarin oil?
- 4 Answers
- 12369 Views
- I also Faced
- E-Mail Answers
Answer Posted / r.kalaiselvan
hi
we are using glasarin oil inside the pressure gauge to
use the gauge in vibrating area
| Is This Answer Correct ? | 23 Yes | 0 No |
Post New Answer View All Answers
How to check vortex flow meter is in good condition while we do not having calibration setup?
principle of dead weight tester ?
With N nodes and B branches what will have a network ???
Hello to all....I am an Instrumentation Graduate and i am passed out in this year only.. I am unable to find the job in my core instrumentation.. so any boby tell me how to and where to search the job....please...and also tell me i there are any courses offered in the instrumentation stream so i can do it... you can send your suggestions to my mail-id i.e Ganesh20084u@gmail.com ... please..
please tel me the calibration of pneumatic controler.
How is work 5/2 sov?
what is the difference between attemperator and desuperheater ?
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
Please send me the sample question of Instrumentation of hpcl/iocl exam. my mail id hihi_kiholo@rediffmail.com
What is the differerence between hysterisis and linearity.
what is the importance of CV in the control valves? how it is calculated?
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
components of control circuit belongs to control valve
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
Why use ball valves on Gas pipelines instead of gate & or globe valves...means basic diffrence or use of these valves..how designers knows this type of valve with rating is required...
