Interested to Buy Any Domain ? << Click Here >> for more details...
I have seen the Temperature element (T/C & RTD) installed
in process line on 45 degree position, Why? What it mean?
How many types of tapping position for temperature elements?
- 4 Answers
- 11813 Views
- I also Faced
- E-Mail Answers
Answer Posted / haridass
The temperature probes will be located in straight for the
pipeline medium temperature measurement,
but in the tank it can be only located at side of the tank
at perpendicular or 45 degree position (not straight),
if it is quiet perpendicular mean it can measure only when
the liquid reaches the probe level,
the 45 degree location helps to measure for the wide level
of the liquid in the tank.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
What is 3 element control system
why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??
field bus transmitter calibration procedure tell me
Can any body tell me about SAP MAINTINANCE MODULE. WHAT IS its function and application. And study material Source about it. I shall be very thankful.
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
How we calculate orifice plat size???
What is stripper & spilitter ? Diffrence in this.?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
How d.p. Transmitter can be applied to open tank?
i am from instrument branch i want paper patern of mahagenco . any pevious years paper regarding my branch send me please . please.....
i am having information technology branh ....... can i prepare for psu exam
what is the field bus calble ? what are diffrences in orang colur cable and black coular calble ?
Any body have know try work calculation ???
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
Introduce yourself which is not present in your biodata?
