Why in USA supply voltage parameters(230V,60Hz)are
different,is there any advantage please brief.
- 1 Answers
- 4788 Views
- APC, DRJ ARDE, I also Faced
- E-Mail Answers
Answer Posted / ankush miglani 09718151073
dear in actual wat happn in 19 and 20 century the t/fs and
m/c becoming very popular. these two gives the best o/p at
low frequencies like synchronous generators at 2hz fr.
bt now the transmission lines require high fr to transfer
the voltages without or at minimum loses.
so standards are defined
for high fr low voltage and for low fr high voltage
for a fr of 60 hz only 100-120 v is sufficient
and for 50 hz 200-240 v
some contries adopt the formal one while other adopt the
later one.
now see the case of japan in some area 60 hz is used while
in some area 50 hz is used
jisko jaisa convinient lga us contry ne wohi adopt kr liya
| Is This Answer Correct ? | 10 Yes | 2 No |
Post New Answer View All Answers
An active element is one which a. Supplies energy b. Absorbs energy c. Supplies energy and convert energy from one form to another
Starting current of a 10 HP induction Motor is ______ time’s full load current.
what is the formula of starting current of 3phase and 1 phase motor???
Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?
How efficiency of thermal plant can be improved?
how many safety really of DG sets.
During underground cabling in landscape area what did we cover the cable with to prevent the electric shock & protect the cable?
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
Dear Brother can u tell the proper size selection of cable & the fault level calculation of braker, busbar etc. pls mail me at azeemk30@gmail.com
Under wat condition statcom operates as an inductor for the transmission line?
how to calculate current and voltage in a same circuit?
can any one tell me about the Extra low voltage systems?From where we give supply to these type of systems??
Why using synchronising methed in DG's sets?
how a resistor resists to flow the current?how an inductor oppses the sudden change in current?how a capacitor opposes a DC voltage.
What should be setting for alarm,tripping and cooling fan on for power transformer's oil temp. and winding temp. indicator?
