what is the si unit of pressure?
Answer Posted / kaja farkhan
pascal(pa)
Is This Answer Correct ? | 14 Yes | 0 No |
Post New Answer View All Answers
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
What is intrinsically safe system?
Can any one send me IOCL instrumentation question papers.. i dont know the pattern of the questions and what to prepare can any one help me on this .. my email id is anwarnishil@gmail.com
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
I wnat to practice more online type questions .so will you show them me to take a practice test?
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
Derive capacitance to 4-20ma conversion formula / relation in capacitance type pressure sensor?
hye SAM acn u send your e mail id, so that i can solve my query through e mail?
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
send me last 5 years questions asked in rrb chennai, for section engineer
please send the drdo exam paper
A valve in series with an orifice plate (DP transmitter), is aligned for constant pressure in the pipeline, if there is an error dx, How to align it in process.
What is the difference between conductive lined pipe and conductive unlined pipe? Why do we see that?
how to calculate range of level transmitter?
What is hp & mp seperator .& what is its working principle ?