Answer Posted / saravanan
first see the total load current......based on the load
current cable size is selected...
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
How to synchronization will be done between two DGs ?
What is VSCF windelectrical system?
why swityard is necessrry requirement in any bis power distributin systems?
Why open circuit test of transformers is conducted at rated voltage??Why not any other voltage??
how calculated Transformer losses.
why the NGR (neutral grounding resistor) always OFF during DG off?
What are books to be referred for KPTCL exam?
what is relay what is protection & contact multiplying relays where it is used function in brief
Difference between control junction box (cjb) and power junction box(pjb)?
What are merits & De-merits of State-Space Method? What is series programming, parallel programming, general programming & direct programming ? And, difference between these programmings Techniques ?
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
what is the excess air in furnace
Is it possible to download the Siemens Selection Chart(TYPE 2 coordination) for 1) fuseless selection 2)Fuse selection
why we permissive overreach in distance protection.where it is applicable to use in long r short lines
What is the real function of reverse power relay in generator panel while syncronising?
