The current though a branch in a linear network is 2A when
the input voltage is 10 volts. If the voltage is reduced to
1 volt, and the polarity is reversed, what is the current
flowing through the branch ?
Answer Posted / iamdon
From the first statement of line..
Resistance of branch=10/2=5 ohm
Current flowing through the branch=1/5=0.2A
Is This Answer Correct ? | 7 Yes | 10 No |
Post New Answer View All Answers
Incoming line 11kv And transformer capacity is 2500kva. Consumption load is 1300A. Then fuse capacity is 11kv line.
What will be the effect of circulating current in HT xlpe cable when both the armour ends are grounded. Will the termination fils after some time in case of 33 kv supply.
What are IR values and what it should be for coil and for insulator
A 11KV, 1200 A breaker combination fixed in a cubicle for HT motor.Is normally for 11 KV motor fuse is using? if Yes, What range fuse is required?
give me applications of sequence bridges . (used in 3 phase un balanced systems)
what are the things that can cause a three phase motor to crawl?
what will be project cost for 100 kv transformer connection under oyt scheme.
From reading, Under voltage relay used also as phase sequence relay now, Why I use under voltage and phase sequence relay in the same circuit (ATS)?
How LT megger works ?
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
Whether amorphous core transformer is available in India?.If available then up to what rating of voltage and KVA?.
At what factor resistance r of a conductor depends?
What is the reason for using a GE G101 MCB in place of an EP102 MCB if both are capable of AC circuit protection?
What is EHT tariff or Power factor Tariff ????
what is ps impedance test