what is difference between RTD , thermo couple and
thermistor in general ?? (except temperature co-efficient )
- 5 Answers
- 17132 Views
- Bilt, I also Faced
- E-Mail Answers
Answer Posted / r.kannan
with t/c we can measure upto 1700deg. but with RTD 600
degree is accurable. in t/c only the tip is sensing point
wihre in RTD the average value will be taken.
| Is This Answer Correct ? | 9 Yes | 4 No |
Post New Answer View All Answers
POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDGE OF THE INPUT TO THE LEADING EDGE OF THE OUTPUT IS 10 ns. THE TIME FROM THE TRAILING EDGE OF THE INPUT TO THE TRYLING EDGE OF THE OUTPUT IS 8 ns. WHAT ARE THE VALUES OF tPLH and tPHL?
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
What is three element drum level control system why its better than single element?
can anyone tel the syllabus or previous year question paper for BHAVINI(EIE)2014.
steps for installing orifice plate?
how to calculate control valve bonnet size?? or how to select its material?
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
what is the diffrence between pressure safety valve & pressure relief valve....pls
What is 3 element control system
Explain the key components of control loop?
Describe the function of Accumulator into the Pump
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
which type inter lock use in petrochemical refinery,and oil & gas?
Calibration procedure for Electro magnetic Flow meter
