Which of the following instruments consumes maximum power
during measurement?
- 3 Answers
- 10701 Views
- I also Faced
- E-Mail Answers
Answer Posted / mahi_alwayz
a) induction instruments
(b) hot wire instruments
(c) thermocouple instruments
(d) electrodynamometer instruments
| Is This Answer Correct ? | 32 Yes | 6 No |
Post New Answer View All Answers
Which is your favourite subject & explain any one topic of it.
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
What do you know about gail?
Which type of pressure can be measured by primary elements?
what are the selections available in configuring a burnout protection of a controller? thanks
Boolean algebra
Difference between 2-Valve Manifolds, 3-Valve Manifolds and 5-Valve Manifolds 3 with diagram
what will the sending unit in the fuel gauge utilizes?
In dcs panel we are using diff type of modules ?what is module ? what is the use of modules ?diff type of module?
steps for installing orifice plate?
What is the difference between mmwc and mmwg?
how many type of plug are used in pneumatic control valve,name them.
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
