What is the allowalable frequency variation in India and in
US?
Why there is the difference?
Answer Posted / iamdon
The allowalable frequency variations in
India=+/- 3%
US=+/- 1%
The reason for this variation
1)In US, there is an adequate generation for matching the
load.
2)In US,there is surplus spinning reserves for emergencies.
In India,we are facing challenges in these areas.
Author:arbelectbit@yahoo.com
Is This Answer Correct ? | 30 Yes | 6 No |
Post New Answer View All Answers
When can we take Neutral as common neutral link?
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
What would cause a 240v choke that should give 110v out on a 16w lamp to gradually increase to 160v?
What is called limb of a transformer?
What is a advantage of Self Reset Lockout ? On Fault breaker get trip & fault no longer exist then self reset lockout how inform us?
What Is Connection APFC Panel In Compony.
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
what is the function of statics switch in ups and tell me parts
why different series of vfds (like allenbradley)are used in industry ?
why we can use 1 to 5V dc
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
how mass curve differs from hydrograph.
what is the setting of locked rotor in HT motor ? (answer expecting in percentage)
The specific heats of the gas at constant pressure and constant volume are respectively 1.0 kJ/kg K and 0.72 kJ/kg K; the value of R for the gas is
can the measured percentage error during calibration of single phase energy meter be negative?