. What should be the minimum and maximum ohmic value for
earthing?
- 1 Answers
- 3784 Views
- I also Faced
- E-Mail Answers
Answer Posted / shariff
There is no specific value as such, but usual values are as follows.
1) Generating Stations less than 1 Ohm.
2) 220kV Sub stations up to 1 Ohm.
3) 66kV S/S up to 2 Ohm.
This should be as low as possible.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
What is the tension required for the 25000 CFM AHU belt
what is the disadvantages of common earthing for AC and DC equipment? (i am talking about inverter control room and inverter duty transformer earthing is common...?)
Can u tell me design of switch yard
how we can find of current direction(supply comming/out going direction) when a transmission line passing through sides.
Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend
what is the Earth Voltages in Power Plants, Sub-stations, Industries, Residential & Commercial Buildings.
What is the lifetime of a Thyristor? Is there a recommended lifetime for thyristors after which they should be replaced?
What is the comparison between 30mA DP RCCB and 100mA DP RCCB and can replace it against 63A MCB
What is meant by reverse polarity and how it can be fixed?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
What is the resistance of the field winding of a d.c. Shunt generator kept low?
A Question Like A Wire Is Wound Whose Resistance Is Some 132. 44647 Ohms. If A Voltage Of 30 mv, 296 Ma Current Is Applied To It What Is The Resistance.
Is RTCC panel needs any control supply.
Write down the design procedure of commutaj.
What is the purpose of stablization resistor in high impedance bus bar protection
