What is the equipment used to control the generator output?
Answer Posted / satish sharma
AVR (Automatic Voltage regulator)
Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
can we install HT panel & LT panel side by side or how much clearance is required ?
Why an ac solenoid valve attract the plunger even though we interchanges the terminal? Will the poles changes?
How to measure the Harmonic Distortion of UPS ie THD?
How to design harmonic filter at the project stage without nowing the harmonics levels
What is phase cross over frequency?
How to calculate of maximum demand if given 628kw, 785kva, 0.8 p.f.
What is the function of retrip in busbar?
During regenerative breaking= A rotating magnetic field is reversed B slip is positive C torque is positive D slip is negative
I want formula to calculate current loss with distance in km.I searched many sites but didn't right answer.Plz reply me
The windings of a transformer are divided into several coils, because?
Define delay time.
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.
How to calculate the efficiency of Turbo Generator(Alternator) in general....?