Why we use signal&voltage isolator between source n load.
Answer Posted / pinky
to avoid the back flow of signal 4m load 2 source... tis
avoids interference...
Is This Answer Correct ? | 13 Yes | 0 No |
Post New Answer View All Answers
Describe the difference between p-type and n-type semiconductor materials.
Why ce configuration is most popular in amplifier circuits?
Draw a schematic diagram of a Half Adder. Can you draw the same using only NAND gates?
what is receiver device in ir receiver which catch over signal of ir?
can anyone provide apgenco previous question papers and materials to this id balarajyarajala@gmail.com
What is fbus protocol?
Why are the 2 input terminals of an op-amp are called as inverting & non-inverting terminals?
How can a thyristor turned off?
What are the properties of FFT? What happens when you pass a signal of 1000Hz through an FFT?????
Define what is meant by voltage regulation of a dc power supply?
is there any method to interact with LnT ER300P trivector meters and fetch data from that online from remote? the distance between the meter and the pc will be about 4 km.plz reply.thanks
convert d flip flop to jk flip flop using mux
Define what is schottky diode?
What are the advantages of igbt over bjt, mosfet?
i am b.sec with PCM now what can i do for higher education