what is the meaning for 'prime cost' in civil construction
contracts?
- 3 Answers
- 16526 Views
- EPPPL, Nagarjuna Construction, I also Faced
- E-Mail Answers
Answer Posted / jayavijayan k (ivrcl)
While working out the abstract for a job, it is not always
possible to define everything necessary for the completion
of the building. For example, certain items such as water-
supply fittings, plumbing fixtures, etc, are to be decided
by the Architect, later on. Hence it is not possible to
work out the cost of such items at the time of inviting
tenders. So a lumpsum provision is made for these items. It
is called PRIME COST Provision, and is subject to
adjustment against actual items selected later.
| Is This Answer Correct ? | 29 Yes | 3 No |
Post New Answer View All Answers
Please tell me Detail cost of providing& laying nominal mix design 1:2.5:5,40mm nominal size.curing complete e/c cost of form work in foundation and plinth i/c carriage.
What are the reasons for geotechnical site investigations in uganda?
manhole chamber having height of 2300 mm and thickness of brickwork is 230 mm and dia of opening covering is 560 mm and bottom length vertical is 1500 mm (1:4) brick masonry and plaster 12 mm on both sides..how to estimate the no bricks used with mortar cement bags and sand for total chamber including plaster.
how to calculate the scour depth
Iwant to calculate the production of 1 labour for concrete casting which includes shuttering,scaffolding,steel fixing,concreting, deshuttering and curing in 8hours.But i am not able to determine it approximately would you pls.??
how to calculate cut length of re-bar in a circle . because we not place same length of re-bar in whole circle maximum in center and minimum at corner so how to calculate middle bars???
find the discharge of water through a horizental venturimeter having 400mm dia at the inlet main and 150mm dia at thorat.if the diffrential gauge between inlet and thorat shows a pressure head of 25cm mercury. assume coefficient discharge 0.98 and specfic gravity of mercury as 13.6.
How to get MEP technical,instaaltion & testing data for interview?
The foundations are placed below ground level, to increase?
Which ratio use for cement selery???
What happens when water mixed with cowdung is used for priming instead of water for lifting water in pumps?
What is semirigid connections?
how can we calculate steel value, depending on load
i want to ecil (Electronics Corporation of India Limited Hyderabad) previous civil engineering question papers immediately please.............
what is BPM in concrete demolition hammers. what is better a higher value or lower
