where is used dc volage transformer,and what is highest
capacity of transformer
- 2 Answers
- 4196 Views
- I also Faced
- E-Mail Answers
Answer Posted / dinesh lokhande
If question is where is DC voltage used in transformer then
it is correct, used for measuring resistance.
To elaborate,
DC voltage is used to counter effect inductive reactance
of winding. As winding put on core coil assembly consist of
resistance as well inductance, for measuring pure reistance
we pass DC current through winding.
Impedance = resistance + Inductive reactance.
Inductive reactance = 2*pi*f*L where,
L = Inductance
f = frequency which is zero for DC and hence Inductive
reactance becomes zero for DC supply.
measured impedance at winding terminal is pure resistance.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
What is online and offline ups? how does it works?
Power Factor Correction Panel (Manual & Automatic)
How to design the earth grid for lightning protection in an industry
how we provide neutral earth on synchronising panel as per electrical standards?
what are problems caused by the pdu in rack server
On what basis the the size of Lightning arrester for buildings are selected ?
Why in ESP Positive earthed
What are the section criteria for cables. Now everywhere XLPE power cable is used or PVC is also used?.
How to dimensioning SDCCH, LAPD and CS7 signaling on GSM?
What is The Resistance Formula
How to Calculate Transformer Earthing Electrode Rod Size both Body and neutral Earthing ? Any Standard Formula? Please Suggted
List the time domain specifications.
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
what are safety measures in /control in diesal engine/ explain them?
