sometimes, eventhough the HV side of the transformer is
opened there is a voltage in LV side .How is it possible?
Answer Posted / shyam
bcoz even if the hv(secondary side) is opend there will be
a small amount of flux flows through the core of the
transformer
Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
Difference between Lugs and Thimbles
What is effect of over voltage and under voltage on ACB
Testing procedure of DG alternator stability test
what is the formula for hv test for cable and circuit breaker..????
What is sink and source?
In both 600/1000 V cable and 450/750 V cable, we can supply 415 V. However for distribution, all utilities are using only 600/100 V instead of 450/750 V. What is the reason?
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
do you have some of interview Questions in power and genrator section in general whith answers
What is CCT (Correlated Color Temperature) ?
how hydrogen cooled alternator undergo maintanence ? that is hydrogen when come in contact with air can result into explosions .
what is dry and wet frequency withstand voltage? why & where it is used??
In India the supply voltage is 230 volt A.C. During the negative half cycle phase becomes neutral and neutral become phase? or what will happen during negative half cycle? how the electrons flow during positive and negative half cycle?
at what basis/standard we have to arrive the current density of aluminium/ copper in busbar?
What is the difference between electrical earthing and electrical grounding?
what is the difference between earthing and unearth