can we light the mercury vapour (tube light)with out a
1).starter and 2).choke in our homes if yes explain how?
Answer Posted / shyam
we can't light the mercury vapour lamp with out starter &
choke becoz to light up mercury lamp above 230v is
essential hence it is done through choke to get break the
elasticity of the atoms& to get free electrons
Is This Answer Correct ? | 2 Yes | 5 No |
Post New Answer View All Answers
What is the difference between resistance grounding system and resistance earthing system?
What do you mean by an instrument transformer?
What is ideal IR values for ground and neutral.
use of PIR in ehv breaker
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
WHAT IS MEANING OF Gg & Gg IN hrc FUSE
State kirchoff current law?
What are the difference between CT/PT operated Meter and RRAMR Meter for HT/LT application?
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
can i use 2000/5A Clamp meter to measure HT cable
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
what is the effect of connecting three phase supply lines to three phase auto transformer output terminals through a fuse of 10Amp and a circuit breaker (MCB). Is this connection permanently destroy the transformer?
What would cause a 240v choke that should give 110v out on a 16w lamp to gradually increase to 160v?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
please explain how to do 'pole drop test' on generator?