how can we calculate that how much capacitor is needed for
a system to increase the pf?
- 5 Answers
- 7485 Views
- I also Faced
- E-Mail Answers
Answer Posted / dinesh lokhande
A simple formula will help to co-orelate power factor, KW
load, and Kvar (i.e reactive power) required.
kvar = KW (Tan Qi - Tan Qd) where,
Qi = Cos inverse pfi = Initial power factor angle
Qd = Cos inverse pfd = Final power factor angle
After calculating Kvar we can select no of capacitors
required by looking at capacitor catalog.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
i am venkat i got gre 930(verbal 270 quanta 660) and my toefl score 105..here question is why u got less score in gre ? what i supposed to tell...any chance of rejection is there...my accadamics record is very good
Discuss about gear cutting machines.
how to deside the capacity of chock for drive?
How to Calculate the Fault Level of Electrical Installation
please explain how to do 'pole drop test' on generator?
What are the parameters of water ( Water quality )to be monitored in Centralised HVAC ( water cooler chillers )
what is cogging and crawling
WHAT IS SUBSTATION & ACCORDING TO VOLTAGE HT,EHT SUBSTATION EXPLAIN IT
what will happen reduce the transformer voltage from 415v to 406v, is it save the energy,? are this methodis good to reduce the energy.?
We are planning to synchronized DG's with our captive plant in the event of black start of plant, but before sync we checked voltage of DG with our plant voltage and it varies from 5 V to 450 V. So in this condition how we can sync DG with plant ?
Explain Circuit Breaker Trip Characteristics in detail.
how to flameproof electrical motor on the shaft?
What is transformation ratio what it describes?
what is saturation kit?which use above 15 kw motors panel side.
What is the maximum percentage voltage drop (vd%)for a motor control center
