Interested to Buy Any Domain ? << Click Here >> for more details...
If AVR fails in DG set what will be the affect?
- 17 Answers
- 36533 Views
- GoodYear, Hotline Glass, HSL, I also Faced
- E-Mail Answers
Answer Posted / ajay
1. If the avr is not giving any output voltage ie DC to the
excitor then no voltage build up will be there.
2. If the avr is not changing the dc voltage as per load
demand then voltage variation will be observed.Which means
the automatic rerulation function of avr wrt load is not
working.Hence avr needs replacement.
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
how we findout a ignater is faulty or not?
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
List the characteristics of filter?
What is 11 N1 and 12 N2 in single phase Transformer ?
what is the maximum temperature rating of a thhn insulated conductor?
What would cause a 240v choke that should give 110v out on a 16w lamp to gradually increase to 160v?
my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.
What are the characteristics of negative feedback?
WHAT IS THE DIFFERENCE BETWEEN GENERAL INVERTER AND SOLOR INVERTER TELL ME PLZ
If we have 11 kv RYB Phase single core cable near about. Then wht effect and losses
in dc shunt motor if field winding is shorted then
What is the resistance of the field winding of a d.c. Shunt generator kept low?
what are the preventive maintanance actions taken for air circuit breaker? please answer me
WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.
