What are the factors to be considered during the
Synchronization?
Answer Posted / yogesh singh
1. Frequency must be same
2. Voltage must be same.
3. Phase sequence must be same.
4. Transformer vector group must be same
Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
what is tri state logic gate
What is the requirement of grounding the neutral of single phase generators on load? If the neutral is not grounded, what will be the effect?
sir, Is their any measuring unit of knoking? please explian?
how to deside the capacity of chock for drive?
What are two contours of nichols chart?
Please provided formula for calculate the cable size from step up transformer to M.V panel, run overhead aluminum cables, total load is 5mega watt, total length 900 feet.
What conditions are required for transformer to operate at low frequencies ?
i need the curve duty cycle and amper for (150 kva @50% dyty cycle) transformer turn ratio :19 and vin 400
There are a trformer and an induction machine. Those two have the same supply. For which device the load current will be maximum? And why?
What are the main significances of root locus?
What is the range of the stator resistance of 3 phase induction motor?
what is the maximim current drawn by 1 phase and three phase welding machine
we have two motors 1250kW,6.6kV to be coupled on the same shaft ,so please provide assistance for their synchronisation.
What would cause a 240v choke that should give 110v out on a 16w lamp to gradually increase to 160v?
What are the significant parts of dc generator?