Answer Posted / shyam
in delta connection there is no ground like in star
connection.so it is easy to locate the armature or rotor at
the center of the stator of induction motor
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
what is the principle of the single phase energy meter? and,what is the advantages and disadvantages of single phase energy meter?
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
can someone explain that how the speed of the protection system affects the fault level calculation?
What is difference between insulating medium and fault current interruption medium in a switching device.
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
WHY NUTRAL GROUND SYSTEM USED IN 33KV SYSTEM
In how we connect watt meter for open & short circuit test of a single phase transformer.
what is the current density of copper & alluminium.
How to select circuit breakers rating eg. if i select a circuit breakers of capacity 40 amps DC with operating voltage 28 volts and if i what to use same circuit breakers for 300 Volts DC application what is the current rating of this circuit breakers.
There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
(1)The demand for electricity , the amount of renewable generation available, the amount of fossil fuel generation available and the cost of the fossil fuel generation are shown in table below period(hrs) demand(MW) renewable (MW) fossil- fuel(MW) cost of fossil fuel(MW) 00.00 - 01.00 2000 1800 2000 30 01.00 - 02.00 2300 2500 2000 30 02.00 - 03.00 2500 2700 2100 45 03.00 - 04.00 2900 3100 2100 50 04.00 - 05.00 2700 2600 2500 45 05.00 - 06.00 2400 2000 2700 50 06.00 - 07.00 2200 1800 2000 36 07.00 - 08.00 2100 1600 2000 36 Assuming that the renewable generation incurs zero cost, determine an optimal generation schedule(specifying the amount of renewable generation and fossil fuel generation used in each period, the cost for each period and the overall cost for 8 hours.)
How to do fabrication , busbar and wiring cost for : 1. LT Panels 2. C& R Panel
Why we specify TNC switch with 1NO 1NC ,2NO 2NC ? how we get connection.?
When we giving the 3 phase supply to ups system how to coming netural?
