Interested to Buy Any Domain ? << Click Here >> for more details...
What will happen if we give transformer a dc not ac
- 5 Answers
- 9644 Views
- I also Faced
- E-Mail Answers
Answer Posted / shariff
If DC is applied to the Power Transformer, this is basically a inductive coil, as freq. is zero is DC, inductive reactance offered is zero i.e. XL=0, then it is as good as short circuiting the DC power supply, if the DC power supply can feed that much current, then that power transformer wdg will burn or due to its resistance the wdg may get heated up.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
What is meant by short-pitched winding?
how to design the heater in temperature control unit to heat 50KL of water?
hi frds, i m electrical engineer.can i get cdr for electrical engineer if u have then send me on my mail id its jayesh_ee88@yahoo.com.please help me frds
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
take 100kva DTR( delta/wye ), what ll happen if we connect 11kv to LT side instead of connecting to HT side? will the DTR behave as a step up transformer or something else????
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
What is a diode?
why 15 kw motor winding resistance is low then 5 kw motor winding resistance?
How to Calculate The sag of OPGW in Transmission Line???
What is the effect on 3phase induction motor if current setting knob of DOL kept at minimum current?
Explain forward resistance, static resistance and dynamic resistance of a pn junction diode.
what is the difference between fault current ant short circuit current?
State uses of different types of stsrters with different capacities of motors as below: a. up to 5HP b. above 5hp to 10hp c. above 10hp to 20hp d. above 20hp
IF TVM OF TRANSFORMER SHOWS POWER FACTOR ON 33 KV SIDE AS 0.97 LAGGING AND ON 132 KV SIDE IS 0.75 LEADING.IS THIS CORRECT.WHERE IS PROBLEM.
What does bode plots shows?
