Interested to Buy Any Domain ? << Click Here >> for more details...
Brief working principle of fluorcent tubelight,function of
starter & choke.
- 3 Answers
- 24163 Views
- Havells, I also Faced
- E-Mail Answers
Answer Posted / rajeshsan
The Filament in lamp is located in either side of the Tube. And The tube is filled gas. The choke will be connected in series and one end of both the filament will connected to the starter. The starter is made up of Bi-metallic filament.
The 230V AC supply will not enough for electrons to flow inside the Florescent lamp.
Hence once power is switched ON. The current flows in the starter and starter will begin to flickering which will leads the choke to induce more voltage say 1000V Appox.
| Is This Answer Correct ? | 42 Yes | 8 No |
Post New Answer View All Answers
if 2 coil of 1000W connect in series and 200 v is applied across it . then what is the total power of coil when coil have only resistive load .
Why have to use copper cable for local isolator to motor ?
I have c license but I don't know eligibility of Max Kilo Volts under the electrical licensing board.
various transmission tower like .,D tower ,K.C.O tower ,C.C.O tower,K.C.R tower ,C.C.R tower ,H.C.O tower in different tons.
How u can give the overload setting to any motor protection relay for a HT motors with formula and Example?
Load break swicth maintenance procedure.
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
Whether IP65 enclosure box blocks ventilation if driver for LED have to enclosed inside IP65 box
During regenerative breaking= A rotating magnetic field is reversed B slip is positive C torque is positive D slip is negative
What is the bundle conductor?
v/f drive basic princeple
how we can calculate 2 phase welding transformer rating or total power?
Give the topology of current amplifier with current shunt feedback?
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
sir& friends i want the collection of recent quetions asked in interview of top most companies please send me on my email san.jsr@hotmail.com
