what purpose of the percentage impendance in transformer
- 3 Answers
- 4999 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajeshsan
The Transformer impedance plays a major role in power system.
The Transformer impedance will reduce the fault current. If there is high impedance transformer placed between the circuit. The transformer will acts as isolation to fault current.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Mention the methods for starting an induction motor?
Why Stabilising Resistor used in REF circuit ?
What is the reason for using a GE G101 MCB in place of an EP102 MCB if both are capable of AC circuit protection?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
how much flux density of CRNO core
Metal covered multiconductor cables shall employ a marker tape located within the cable running for its complete length in lieu of cable surface marking. Is it true or false?
Name one of major transformer company in KSA ?
In which of the following case, the rotating magnetic field is reversed? A regenerative breaking B plugging C dynamic breaking D forward motoring
if 2 coil of 1000W connect in series and 200 v is applied across it . then what is the total power of coil when coil have only resistive load .
why use phase displacement in transformer.and effect of phase displacement on transformer
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
when the time of backcharging the transformer three phases only enough or three phase with neutral is must.from these which one is the best one.
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
Define liftable weight of a transformer? Does the total weight of transformer include oil weight?
please explain to me how to calculate current,voltage,resistance with formula??
