Why generally the transformer primary is connected in star
& secondary in delta
Answer Posted / iamdon
Primary side is that side of transformer through which
source of power is connected and secondary side is that
side through which load is connected.Star on primary side
has a neutral point which is grounded for protection
purpose.Delta on secondry side ensure that in case of
unbalance the zero sequence current would circulate in
delta and would not flow in line of secondry side.
Is This Answer Correct ? | 14 Yes | 7 No |
Post New Answer View All Answers
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
upto how many load can v connect to stabilizer which is used for tv
How one may guess the direction from which the distribution line is incoming if there is no pole plate on poles?
How to use computer cpu ups use for home inverter circuit board
What it the purpose of parallel phasing transfomers??
How to calculate the Harmonics losses in terms of cost/unit.
In TNC switch, is there any 1NO+1NC block ? and if we move over closing position, is ther any affect on trip position or vice versa?
CAN ANYBODY PLEASE TELL ME HOW TO DESIGN A SERIES REACTOR FOR LIMITING SHORT CIRCUIT FAULT CURRENT??
WHAT ARE THE EFFECTS OF SERIES RESONANCE AND PARALLEL RESONANCE ON THE CIRCUITS PARAMETERS?
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
what are the major & minor faults that occur in an inverter and in UPS ? And how to repair and resolve them ?
Why open circuit test of transformers is conducted at rated voltage??Why not any other voltage??
how to measure dc earth leakage current?
Dear sir, I have completed DECE in the year 1995. I have work experience in HT and LT LINE more than five years. Now i am doing BE in EEE from rajasthan university. After completion of BE,can i apply "C" Licence sir? Please reply.
What is the Load Capacity of Panther conductor (0.2) and dog conductor (0.2)