why the power factor in inductive load is lagging while it
is leading in capacitive load?
- 6 Answers
- 17226 Views
- I also Faced
- E-Mail Answers
Answer Posted / deepak kapil
as power factor is a cos angle between voltage ¤t.In
inductive load current lags,means the voltangle between age
and current goes upto 0 to 90 degree(we assume voltage is
constant).in capacitive load current leds, it means angle
between voltage and current comes down from 90 to 0
degree.And we know cos 90=0,and cos0=1.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
Explain about technical and non technical losses in distribution system?
How to design inductive load for 3 phase 440v and maximum 5 amps for star or delta? Can we use a 15kW, 1450rpm motor for 15kW, 960rpm apllication?If yes.how......n.if thesame motor used what`s it`s sideeefect.
Why the power generated in dams is complex power? Why the generators in dams cannot produce Real power directly (i.e power which has zero reactive part)?
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
Can double compression glands be used with regular cables?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
How we calculate the Multiplying Factor of Kwh meter for 3 phase alternator.
What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?
i've iocl interview.. if you know the interview process please give me information..
detailed procedure how we calculate cost for pcc m10 and rcc m20 including centering and labour excluding steel/ iron
What is the distance between body earthing and neutral earthing.?
We have two APFC panels in same station. I need how to connect CT in two APFC panels.can we take one CT in series connection or two separate CTs.
In the magnetic fluxes, what is the role of armature reaction?
Dry type transformers
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
