what will happen if dc supply is given to ac motor?
- 9 Answers
- 14088 Views
- CTS, I also Faced
- E-Mail Answers
Answer Posted / rajasekhar
first of all for an ac motor there must be some alternating
flux if it is constant flux e=0, infinite currn flow
| Is This Answer Correct ? | 10 Yes | 5 No |
Post New Answer View All Answers
In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.
why motor range is available 22kv,30kv,37kv,45kv and so on? why motor range is not available 21kv,24,25,26,27kv and so on?
We need to current density & short circuit calculation at 65kA for aluminium & copper busbar.
why do we carry out winding resistance test?
Importance of fault current in power transformers and how to monitor the same? How is it different from winding temperature?
What is meant by load angle of an alternator? Upon what factors does the load angle depend?
If more than rated DC voltage appears across trip coil of the breaker, what will happen? e.g. in 110V DC circuit system, if voltage across battery terminal showing 121 V
How npn and pnp transistor works
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
(1)Can earth and be conected together (2) what is the diferent between earth & neutral
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
State ohm’s law?
What types of question are done for diploma students in aptitude test
how much flux density of CRNO core
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
