Answer Posted / mrudang
cu has more strength of heat withstand
cu is melt 300 degree celcius and Al is melt at 160 degree
celcius
cu has less resistance
cu has high conductivity
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
A jet of fluid strikes a plate What was the force required to counter it?
How to test IR testing & magnetic balance test
IF % IMPEDANCE OF A TRANSFORMER IS INCREASED FROM 5.8% TO 8% HOW MUCH THE EFFICIENCY OF THE TRANSFORMER WILL COME DOWN?
What do you mean by transformation ratio of instrument transformer?
two phases with neutral supply can be taken in 3C X 10 sq.mm cable .
HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE 500 TIMES OPERATED.
sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.
71ohm,111ohm,95ohm,179ohm in calculate the total ohm in series circuit
what is difference between elr and R eartl realy.
what's the difference between 'shaft power demand' and 'BHP' , when we consider electrical load list.
WRITEDOWN FEW RELY CODES
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
Define the term factor of inertia.
1.what is difference in maintain Hz again Hz in USA ? 2.how to calculate the battery AH? 3.why are yearly maintained in transformer how many tests in required?
Why efficiency of generator is higher than motor at a particular load?
