a)tell density of steel , concrete, bricks , sand and
aggregates.? b) what is knife test for wooden doors ? c)
what is the meaning of term abrasion? what is tested in it?
d) why pile foundation is provided in BCS?e) By total
station what activities can be performed and on what
principle it works? f) what is creep?
- 4 Answers
- 32353 Views
- I also Faced
- E-Mail Answers
Answer Posted / suresh
continution to the above answer.
the process of wearing down or rubbing away by means of friction is called abrasion.
the resistance to wearing is found by the loss of the material
through 1.7mm sieve.
the black cotton soil has a mineral named montmorillonite,which has extensive shrinkage and swelling
characteristics with the variation of the moisture content.
as this shrinkage and swelling reduces with the increase of
the depth (about 1.5m depth no variation) we adopt pile
foundation for such soils.
by total station the measurement of horizontal, vertical angles and the sloping distances can be measured.
it works on the principle of electronic distance
measurement which based on measuring the phase difference between transmitted and reflected waves.
the increase in deformation (strain) under sustained
load (stress) is called creep.
| Is This Answer Correct ? | 10 Yes | 3 No |
Post New Answer View All Answers
1)What is the total volume of aggregates required for 1cu.mtr.solid hard concrete? 2)What is total mass of wet concrte and dry concrete after 28 days of M25? 3) Is 28 days strength is the final strength of concrete or it gets increasing as the time period increses.? 4)What is the volumetric proportion of concrete grade of M25.M30,M35,M40
What is the wall thickness of NP-3&NP-4 hume pipe as per I.S code
In block work seawalls what is the purpose of slip joints?
The mixture of different ingredients of cement is burnt at?
what should be the PCC ratio to construct a plinth of (40x40x4)ft...??also its estimated cost??
load combinations how many types for staad design purpose?
What applicable rate of wct in bihar
What is the value of live load that should be incorporated in design of locker room and cash vault room while designing a building for commercial bank?
what course did you consider thinking before you enrolled in college?
How does a traffic light signal work ?
Define unit atmospheric pressure? Difference between gauge pressure, absolute pressure?
How much quantity of cement,sand,stone used to build 1 cum of cc road??
what is Brick crushing strength(PSI)?
How to calculate steel for beam slab and column
Design a built-up column carrying an axial load of 1200 KN. Its length is 8m and it is effectively held in position at both ends and restrained against rotation at one end. Assume yield stress of 250 mpa
