Interested to Buy Any Domain ? << Click Here >> for more details...
what is skin effect? why is it absentin dc system
- 22 Answers
- 47075 Views
- I also Faced
- E-Mail Answers
Answer Posted / karthik
The current flow in a multi-stranded conductor tends to flow
more on the outer surface than in the inner surface.This is
due to the reason that the flux linkages in the multi-strand
conductors cancel each other in the inner strands than on
the outer strands.Due to this the current flow varies.Also
no alternating fluxes are produced in DC current flow.So the
skin effect is not defined for it.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
why it is not advisable to run low rating (19KVA) DG sets in parallel for long durations even though they are provided with droop ckts (QDC)
CT Ratio of a energy meter connection is Red Phase : 100/5A, yello Phase : 50/5A & Blue phase : 100/5 A what is the overall Multiplication factor
diff. between tension mode & speed mode
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
can anyone explain the star-delta motor control wiring ,which wire go where and how they operate?
1- What is the Polarization Index number be good for 15KV 3c#500MCM electrical cable? 2- Can I use the IEEE Std 43-2000 to perfom the PI test? Thanks
what is maxemo work permit procedure
what is the difference between megger and earth resister ??
what is the purpose of silicon dropper used in battery charger?
what is self capacitance of inductor
I NEED RRB APTITUDE QUESTIONS AND MODEL PAPER,PLEASE SEND MY E-MAIL joo28_eee@yahoo.co.in
How do you select the pickup value of the relay?
determine two methods to find loose connection in operational electrical system?
what would happen if reactive power (kvar)is increased (more)or decreased (less)? how much exact reactive power should be maintained? and what should be done for that
What is the real function of reverse power relay in generator panel while syncronising?
