Answer Posted / mahavir jagdev
the choke along with the starter is used to give the high voltage start to the tube light which has heating filaments at both ends to ionize the gas inside. once the tube starts glowing then only 90 volts is required to keep it going, so the starter stops the current flow into the heating filaments and the choke uses it's impedence to absorb the extra voltage from 220 volts to keep the tube light voltage to 90 volts.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
What is the maximum operating temperature for a thermoplastic insulated cable?
define superposition theorem thevnin theorem ,norton theorom?
How to calculate capacitor bank size at a load 800kVA.
What is the function of retrip in busbar?
What is the HVDC Transmission System? What are the conditions applicable to lay an HVDC Line?
Where is the best place to mount  distribution panel in a house.
The gauge indicates the number of amps, but what about voltage? How voltage rating (for wire or fuse) determined?
State and define ohm’s law?
what is earth pit , how we can measured it, what earth rods reference
Dear all i want to know SEWA Electrical Supervisor Licence test Previous Year Questions ? If any body know please send to me zohairaukllah@yahoo.com
what is efficient motors and how it is different from normal induction motors
what is the difference between surge protection capacitor and surge arrestor
condition Autotrip facia come on control panel of electrical transmission line?
which book to refer in electrical engineering for iocl exam & which book for general english.
what is photo voltic cell,& what are the materials associated with that?and any spcifications like volts/cm etc?
