how we select the fuse and OLR rating for 3 phase
induction motor from 1HP TO 100 HP?
- 2 Answers
- 11462 Views
- Thermax, I also Faced
- E-Mail Answers
Answer Posted / ram
See the full load Current,(It is written in the motor name
plate)
1st:set the fuse to be around 2*Full load current
2nd:Set the OLR to operate at 95% of FLC to get more
operating Life for your motor.
Note:Couple the motor to the load and see How many amps
draw and set it Higher the load by 5% and make sure the
Load current not grater than Motor Name plate current.
| Is This Answer Correct ? | 12 Yes | 4 No |
Post New Answer View All Answers
WHAT ARE THE DISADTAGES OF SINGLE-WIRE-EARTH-RETURN SYSTEM USED FOR RURAL ELECTRIFICATION?
what is draiv work
What is turn ratio of a transformer?
which of the following elements is not present in stainless steel
I am experienced with house and industrial wiring but I don't have any licence how can I apply an licence and which type of licence i can get i didn't complete deee just only experience
how to calculate percentage impedence at 75 deg C at normal tap
what is the star delta connetion and how can do it a three phase motor with control witing with picture
how to select rating of HT Panel
How npn and pnp transistor works
What is the permissible maximum flux density in transformer core?
concept of busbar and load dispatching..?
For a stable system, where should the poles of a system be in a root loci plot?
Please clarify 1. Icw: rated short circuit working withstand capacity 2. Icu: Rated ultimate breaking capacity 3. Ics: Rated service short circut withstand capacity 4. other specification of ACB
In EHV transmission line a neutral grounding reactor is often placed at neutral point of shunt reactors. What is the recommended protection for this neutral grounding reactor? Should I use a fast closing switch to bypass neutral grounding reactor when this protection operates?
How to measure the Harmonic Distortion of UPS ie THD?
