what is the principle of switch gear? where its function ?
- 9 Answers
- 23576 Views
- I also Faced
- E-Mail Answers
Answer Posted / tareq harb
switchgear is simply a protected bus bar against short ckt,
earth fault, overcurrent & under frequency.
Moreover you can monitor Voltage, current, frequency, pf,
KVARs & kw locally & remotely.
bypassing advantage in the switchgear which means
transferring one feeder load to another breaker on the same
switch gear in case of that feeder breaker failure.
| Is This Answer Correct ? | 18 Yes | 4 No |
Post New Answer View All Answers
Control wiring of a dol starter for forward and backward
How would your past experience translate into success in this job?
If I bring a basic electric meter from the States and hook it up in Costa Rica in a development that has only one transformer for the 50 homes, will it still be accurate regarding the usage of kilowatt hours?
whether starting current is limited to rated current of motor through soft starting or it exceeds the rated current?
what is the voltage between earth & neutral in 3 phase electrical connection.
What is the different between conventional MCC and intelligent MCC? Common controller or controller for each bucket
After taking shutdown of 11kv feeder, if you see 5kv by phasing stick in the cable side, is it possible to close earth switch in cable.
how i can calculate the size for fire cable
why the NGR (neutral grounding resistor) always OFF during DG off?
What is meant by Im=30mA@Vk/2. How to know the kee point voltage for CT design
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
how we can calcultae the short circuit level for bus bar
why actual valve timing diagram is different than ideal valve timing digram of a 4 stroke engine?
why we take movement of rotor always in counter-clockwise direction in 3-phase induction motors?
what is the relation between knowing of the distance between power transformer and the capacitor feeder in case of parallel operation
