Answer Posted / vinay harit
if we known the pesentage of impedance then by using this
formula we can calculate the fault Lavel.
fault lavel in MVA= Rated KVa/% of Impedence
OR
Fault Lavel= 1.732xFault Currentx Rated Voltage
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
how to calculate percentage impedence at 75 deg C at normal tap
what is the purpose of using filters in a protective relaying scheme?
3phase cable calculation formula by motor load
WRITEDOWN FEW RELY CODES
how can we make cable shedule for controll wiring ? which details must be required for it.?
along with technical test papers
how does an centrifugal and screw type chiller will work. which chiller efficiency is high and why.
what precautions to be taken while desigining a LT,HT panel. Eg-LT panel PCC panel with ACB installed. HT panel VCB panel with VCB installed. & what is main diffrence betwn IP54 & IP55 construction of panel.
How can we measure earthing resistance test (Earth meggar) of Transformer neutral pit while in live condition?.
what is circuit recombiner and how it is different from circuit breaker
why moisture formation found in XLPE Armoured cable outer sheath
If a high resistance fault occurs,then what are the changes will happen in the system?
Why should be the frequency 50 hz 60hz only why not others like 45, 95 56 or anything , why should we maintain the frequency constant if so why it is only 50 hz 60hz?
Why negative feedback is preferred in the control system?
Why field rheostat is kept in minimum position while armature rheostat at maximum position?
