Interested to Buy Any Domain ? << Click Here >> for more details...
Why the motor take high starting current for long time(10-
15 sec) which is connected to Blower as compaire with a
motor which is connected with pump with same rating?
- 2 Answers
- 4957 Views
- I also Faced
- E-Mail Answers
Answer Posted / vinayak
Starting current basically dipends on Load. For Motor load
of Blower takes more time due to more time for blower load
(due to roubniest ) to its synchronous speed. where as in
pump achives synchonous speed at less time
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
What does the letter CTNM in negative phase sequence relay means?
How the setting of the vector surge relay shall be calculated when the relay is to be used for Grid islanding application?
How to discuss the phase shift of transformer considering open delta?
What will happened if the neutral of the (star connected secondry) Xformer disconnected? (if its Above KVA rated one)
In ht capacitor ckt we are using LBS Panel it having isolator with fuse, one of HT fuse flash over, so what is reason behind this event.
What are books to be referred for KPTCL exam?
WHAT R THE SAFETIES IN A HIGH TENSION PANEL N LOW TENSION PANEL. ALSO WAT SAFETIES R THERE IN A 200 KVA TRANSFORMER?
what is mean by drives?
Determine the BTU size of an aircon for 20 sq metre room
what is the formula for hv test for cable and circuit breaker..????
how to test YNyn0 vector group in transformer?
What is dynamo?How it works and what is the function of dynamo in a DG.
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
kindly send me 11KV MV motor differential protection procedure by primary injection method.
What is the maximum percentage voltage drop (vd%)for a motor control center
