Answer Posted / anu
Tap changing at HT side is more efficient
Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
why normally Generator rating are between 11Kv to 22Kv?
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
whatare the disadvantages occur,if the form factor of transmission will not be equal to 1.11
Can we convert off line transformer to on line transformer
when qty of cable being purchased is not sufficient according to the standard,what should the inspector do to ensure its quality according to the standard?
which model T or pie model is prefarable in power syatem
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.
What is the formula for calculating the Instantaneous Short Circuit & overcurrent for any breaker
how point on wave controller works.
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
Difference between a pilot wire and a normal conductor?
How to calculate fault level of 11 KV system
what topics we have to concentrate for power grid et.written test.and tell what to read for english synonyms and antonyms.
what is difference between speed mode and torque mode in motor?? explain in simple words please.
Why frequency changes due to load variation in power system ? i.e why when load increases frequency decreases?