What is the most common layer 2 device?
A. Hub
B. Bridge
C. Switch
D. Router
- 20 Answers
- 21684 Views
- IBM, I also Faced
- E-Mail Answers
Answer Posted / nishant mendhe
C b"cos switch is works @ layer 2 n hub is works @ layer 1
| Is This Answer Correct ? | 14 Yes | 0 No |
Post New Answer View All Answers
Can you describe the Authentication Header (AH) Protocol?
In configuring a router, what command must be used if you want to delete the configuration data that is stored in the NVRAM?
How arp brings mac address for switch?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
What is point-to-point protocol in ccna?
Why we use filter option?
What is the function of the Application Layer in networking?
What is the difference between lan, man, and wan?
Which type of updates eigrp protocol do?
What is poe (power over ethernet)?
Suppose we have some switch in network and we are running RSTP how much convergence time will be there if one link down
Explain the types of nat?
What is the mau?
How we can see mac address from dos prompt?
Name the command we give if router ios stucked?
