Answer Posted / swapnali jambhawadekar
since it obeys the law of gear that is the common normal
drawn at point of contact must pass through the pitch point.
also it is very easy to manufacture because of simplicity
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
why stress relieving of stainless steel is not preffered
what is the velocity considering in lube oil drain line for lube of system for steam turbine?
the avg piston speed of an internal combution engine increases as cylinder dimension decreases justify?
How to shut down and overhaul the centrifugal pumps?
Which technology is better for designing an STP system in a Commercial Mall. 1) SAFF (Submerged Aerobic Fixed Film) or 2) FAB (Fludized Aerobic Biological ) or 3) Some other.
Name the machines you know?
explain how do seamless pipes looks like and when they r used?
What will cause if you run your engine in critical RPM continuously?
State the difference between ultimate and proximate analysis of coal ?
WHAT IS MEAN BY DENSITY COMPESATIVE STEAM FLOW EXPLANE?
Is radiography require in IBR piping of size 40 NB(1 1/2" inch)?
respected sir/madam.. i wish to know about the latest mechanical inventions and improvements... hwere can i get them... please respond to me through my id
what is the minimum velocity of cooling water for maximum efficiency of condensor.
what thermo
Explain the difference between shear center flexural center of twist and elastic center?