What is the difference between circuit and network.
- 15 Answers
- 66025 Views
- Jadavpur University, Sail, TCS, I also Faced
- E-Mail Answers
Answer Posted / sindhu
circuit is a closed conducting path in which current flows
or intended to flow
where as network is a combination of electrical components
connected in any manner what so ever
| Is This Answer Correct ? | 78 Yes | 29 No |
Post New Answer View All Answers
What are motor generator sets and explain the different ways the motor generator set can be used ?
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
how to calulate short circuit current for the following: 1.cable connecting 11KV of 22KV/11KV transformer to 11Kv of 11KV/415V transformer 2.what cable size should i use.
In synchronous motor, how the field current is related to armature current..i know its inversely proportional..but concept wise...i was nt clear....pls help me...
transformer spections :: input voltage 0-110-230v; output volage 0-10-12-14v; amp=3A using CRNO CORE, capcaity=50VA primary turns = ? ; secondry turns =?
What is reverse power relay?
What is difference between unity power factor wattmeter and upper power factor wattmeter? In short circuit test of transformer the wattmeter used is unity power factor type or upper power factor type wattmeter?
draw the block diagram of fire alarm?
can we use CBCT in neutral of solidly grounded transformer? in place of three phases we can pass only one phase which decreases the size of CBCT?
DESCRIBEPNEUMATIC SYSTM OF ASH HANDLING PLANT
how to calculate transformer turn primary & secondary side 11kv to 420v
How will polarity test of Dy5 Transformer ?
what is the voltages using in movie theaters??? why ??why not other??
volts=230 c=10mf a=??
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
