When i went to a interview the interviewer ask me a
question for that i cant able to answer him if anyone knows
answer me
How will you design a capacitor bank for a plant? if my p.f
is 0.6 i have to improve it to 0.9 or 1 what kind of steps i
have to do? and is there any formula for calculating this?
- 2 Answers
- 3991 Views
- I also Faced
- E-Mail Answers
Answer Posted / madhu
this is also calculated from power triangle. i.e.,
KVAR=KW/COS(@).
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
hai friends i have BSNL JTO exam on next month so if any body have model question paper or give preparation tips to my mail id kumar4486@yahoo.co.in this will helpfull for my future .plz & thank u by kumar
1. Why is the speed of shunt motor practically constant? 2. Why dc series motor use to start with heavy loads? 3. advantages & disadvantages of separately excited generator over self excited generator?
Either It Possible a dc Motor to Run On Ac Drive [ Ex : ACS 800 , Yaskawa F7 ] If it is Possible How Pls Inform Me dinesh_elect_eng@yahoo.com
what is the difference between RMS & TRUE RMS VOLTAGE
What are the protection required for Transformer, motor, Line, Generator, capacitor, that all i have to refer which standard?(Like Transformer detail IS 2026)
what heppend if we are connected u1-v1-w1 as a star point in the place of u2-v2-w2 in power genration
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
How much dc volt applied in cathodic protection system?
What is knee point voltage of transformer?
Define what is power quality meter ?
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
I need bhel previous year quetion papers for electrical engineering department.I searched but i could not find out
what is a bus riser in power system and why it is used
What is meant by full pitched winding?
Can you tell me more about pu systems (per unit systems )calculation in large power systems? how to get the base for voltage and power in generator, transformator and transmission lines?
