what is the difference between RS 232,RS 485,RS 422, how
they different from each other
- 15 Answers
- 42445 Views
- TCS, I also Faced
- E-Mail Answers
Answer Posted / shahul
RS232
It is limited Distance and the speed is Maximum up to
19.2KBPS for 50 Feet.
only single ended.Only 1 transmitter/1 receiver
Supports only Full Duplex.
Signal level is unbalanced.
Higher output current 500mA
RS485
Multi drop topology and supports both half duplex and full
duplex.Maximum 32 Transmitters and 32 receivers.
Max.Distance up to 4000 feet with 100KPBS
Signal Level is Balanced.
Less output current.
| Is This Answer Correct ? | 14 Yes | 6 No |
Post New Answer View All Answers
explain key exchanges in all security modes WPA,WPA2,TLS?
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
which type of zones used for boiler? & why ?
, Instrument Index, P&ID review, I/O schedule, datasheet, DCS / Analyzers specifications, loop diagrams, hook-up drawings.
How to check vortex flow meter is in good condition while we do not having calibration setup?
Explain the working principle of lvdt?
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
What is megering????
how to calibrate corollaries (Mass flow meter)?
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
what is the difference between attemperator and desuperheater ?
What is the meaning of wet leg
Tell about your IFFCO plant visit.
Explain why plc require in analog input 4-20amp & 0-10 volt?
